GLASS MICROFIBER CARTRIDGES
GMF Series For General Filtration & High Flow Rates At 99.98% Efficiency
Everything has to be a good fit: the quality, the price points,
the customer service, the marketing support and the company’s vision for the line going forward.
Product Information
- FSI-Canton Glass Microfiber cartridges offer a wide array of retention ratings from .5 to 7 microns
- All Glass Microfiber cartridges are produced in-house on the most modern equipment
- Complete in-house testing guarantees a superior and consistent product
- We offer all end cap configurations to fit your applications and housings
- Cartridges have an excellent dirt holding capacity with low flow resistance
- Acrylic bonded media for excellent chemical resistance
- Each cartridge has a non-shedding final layer laminated on the media before pleating
- Media grades available for FDA Title 21 for food and potable water contact
- Hydrophobic media can be produced if required for your applications
- Cartridges are constructed in a clean room environment
- Cartridges may be ordered as final rinsed with 18 mega ohm water
Product Specifications
| TOXICITY | PURITY |
|---|---|
| FSI-Canton Cartridges are manufactured with no additives or other manufacturing agents. | Cartridges are Free of Surfactants, Resins, Binders and Adhesives |
| STERILIZATION | |
| Multiple Autoclaving for 30 Minutes at 250°F (121°C) under no End Load Conditions. In-line Steam Sterilization is not recommended. May be In-line Sanitized with Hot Water at 180°F (82°C) for 1 hour. | |
| Retention Ratings | .5, .8, 1.2, 2.0, 2.7, 4.0, 6.4 & 7.0 micron |
| Media | Acrylic bonded glass microfiber |
| Support Media | Polypropylene |
| End Caps | Polypropylene |
| Center Core | Polypropylene |
| Outer Support Cage | Polypropylene |
| Maximum Operating Temperature | 180°F |
| Nominal Diameter | O.D. – 2.7″ I.D. – 1″ center |
| Lengths | 10, 20, 30, & 40 inch |
| Maximum Differential Pressure | 45 psid |
Build a Product Number
| GLASS MICROFIBER | MICRON | CARTRIDGE LENGTH | CORE MATERIAL | END CAP (HELP?) | GASKET/O-RING | 18 MEGA OHM RINSE | |
|---|---|---|---|---|---|---|---|
| GMF | 1.2 | 3 | E | 2 | B | R | |
| GMF | .5 .8 1.2 2.0 | 2.7 4.0 6.4 7.0 | 3 = 10 5 = 20 7 = 30 9 = 40 | E = Polypropylene | 2 = 222/Fin 4 = 222/Flat 5 = 226/Flat 6 = 226/Fin 9 = Flat Gasket | B = Buna V = Viton® T = Teflon® S = Silicone N = Neoprene D = EPDM | |