PTFE MEMBRANE CARTRIDGES
PTF Series For Temperature, Chemical And Vent Filtration With Optimal Air Or Gas Flow
Everything has to be a good fit: the quality, the price points,
the customer service, the marketing support and the company’s vision for the line going forward.
Product Information
- FSI-Canton membrane filters offer a wide array of micron ratings from .02 to 5 microns
- Excellent for chemical and pharmaceutical filtration applications
- PTFE cartridges are hydrophobic, resisting water while offering excellent air and gas flow
- All PTFE cartridges are produced in-house on the most modern equipment available
- Complete in-house testing guarantees a superior and consistent product
- We offer all end cap configurations to offer you the proper cartridge to fit your applications and housings
- Cartridges are manufactured to meet FDA Title 21 for food contact applications
- Cartridges are constructed in a clean room environment
- Cartridges offer structural stability, long life, and high performance with high filtration area
- Custom applications can be made to meet your pore and density requirements
- Cartridges may be ordered as final rinsed with 18 mega ohm water
Product Specifications
| TOXICITY | PURITY |
|---|---|
| FSI-Canton Cartridges are manufactured with no additives or other manufacturing agents. We guarantee all materials used in the production meet FDA Title 21 of the Code of Federal Regulations 174.5 and 177.1520. | Cartridges are Free of Surfactants, Resins, Binders and Adhesives |
| STERILIZATION | |
| Multiple Autoclaving for 30 Minutes at 250°F (121°C) under no End Load Conditions. In-line Steam Sterilization is not recommended. May be In-line Sanitized with Hot Water at 180°F (82°C) for 1 hour. | |
| Retention Ratings | .02, .05, .1, .2, .45, 1.0, 3.0 & 5.0 micron |
| Membrane | PTFE |
| Support Media | Polypropylene |
| End Caps | Polypropylene |
| Center Core | Polypropylene |
| Outer Support Cage | Polypropylene |
| Maximum Operating Temperature | 248°F |
| Nominal Diameter | O.D. – 2.7″ I.D. – 1″ center |
| Lengths | 10, 20, 30, & 40 inch |
| Maximum Differential Pressure | 45 psid |
Build a Product Number
| PTFE | MICRON | CARTRIDGE LENGTH | CORE MATERIAL | END CAP (HELP?) | GASKET/O-RING | 18 MEGA OHM RINSE | |
|---|---|---|---|---|---|---|---|
| PTF | .02 | 3 | E | 2 | B | R | |
| PTF | .02 .05 .1 .2 | .45 1.0 3.0 5.0 | 3 = 10 5 = 20 7 = 30 9 = 40 | E = Polypropylene | 2 = 222/Fin 4 = 222/Flat 5 = 226/Flat 6 = 226/Fin 9 = Flat Gasket | B = Buna V = Viton® T = Teflon® S = Silicone N = Neoprene D = EPDM | R |